{"id":4284,"date":"2012-04-29T06:00:15","date_gmt":"2012-04-29T11:00:15","guid":{"rendered":"http:\/\/www.scrapbook-adhesives.com\/blog\/?p=4284"},"modified":"2018-08-13T13:58:00","modified_gmt":"2018-08-13T18:58:00","slug":"graduation-banner-card-using-photo-corners","status":"publish","type":"post","link":"https:\/\/www.scrapbook-adhesives.com\/blog\/2012\/04\/29\/graduation-banner-card-using-photo-corners\/","title":{"rendered":"Graduation Banner Card using Photo Corners"},"content":{"rendered":"

Hi there, AJ here to share a fun graduation card made from Creative Photo Corners<\/a>.<\/p>\n

\"Graduation<\/p>\n

Making the Graduation Banner Card<\/h2>\n

\"GraduationPlace your die template of choice cutting side up on your base plate.\u00a0\u00a0 Make sure to lay your folded card stock on top of the die, folded part of the card inside the cutting edge as shown. This will create your shaped card base.<\/p>\n

\"GraduationThis should be the what you have after cutting.<\/p>\n

\"GraduationDie cut and emboss your card front from patterned paper and the same die. Die cut a piece of white cardstock with a slightly smaller die, set aside.<\/p>\n

\"GraduationPlace strips of Crafty Power Tape<\/a> onto the card base and adhere the patterned paper. Stamp a sentiment on the lower portion of the white die cut paper.<\/p>\n

\"GraduationPick your ink colors for the banners, and ink the Creative Photo Corners<\/a> right on the sheet.<\/p>\n

\"GraduationTake one Creative Photo Corner<\/a> and place it sticky side up on to your string. (You will be trimming down the large square side of it.)<\/p>\n

\"GraduationAfter trimming the square down, fold the what’s left of the flap over the string.\u00a0 Since the Creative Photo Corners are self-adhesive, it will hold itself to the twine.\u00a0 Repeat as needed with alternating colors.<\/p>\n

\"GraduationNow you have self adhering banners.\u00a0 Place them on your stamped layer, and secure the twine to with Crafty Power Tape on the backside of the cardstock.<\/p>\n

\"GraduationAttach 3D Foam Squares<\/a> to the back side and adhere to the card front.<\/p>\n