{"id":86851,"date":"2021-12-13T05:00:00","date_gmt":"2021-12-13T11:00:00","guid":{"rendered":"https:\/\/www.scrapbook-adhesives.com\/blog\/?p=86851"},"modified":"2022-10-18T17:55:11","modified_gmt":"2022-10-18T22:55:11","slug":"jolly-button-snowman-tags","status":"publish","type":"post","link":"https:\/\/www.scrapbook-adhesives.com\/blog\/2021\/12\/13\/jolly-button-snowman-tags\/","title":{"rendered":"Jolly Button Snowman Tags"},"content":{"rendered":"

Hello friends! It’s Judy<\/a> with you today to share easy Jolly Button Snowman Tags. So cute and so easy to put together using buttons with Adhesive Dots Medium Ultra Thin<\/a> and 3D Foam Strips Black<\/a>!<\/p>\n

\n
\"Jolly<\/figure>\n<\/div>\n

Prepare Button Snowman Tag Base<\/h2>\n

Use tag dies and die-cutting machine to cut Kraft tag about 2 x 3 inches in size. Then stamp a greeting at bottom of the tag with black ink.<\/p>\n

Build Button Snowman<\/h2>\n
\n
\"Jolly<\/figure>\n<\/div>\n

Apply Adhesive Dots Medium Ultra Thin<\/a> to the back of a 0.75-inch button and place it on the tag.<\/p>\n

\n
\"Jolly<\/figure>\n<\/div>\n

Cut about 0.5-inch piece of 3D Foam Strips Black<\/a> and attach it at the top of a button slightly offset to the right edge of the button. Next, place Adhesive Dots Medium Ultra Thin<\/a> on the back of a 0.5-inch button and fasten with holes horizontal (eyes) next to 3D Foam Strips Black<\/a>. <\/p>\n

\n
\"Jolly<\/figure>\n<\/div>\n

Cut a 0.25-inch piece of 3D Foam Strips Black<\/a> to place at the top of the snowman’s head to make a hat base. Also, cut a 0.125-inch piece of 3D Foam Strips Black<\/a> and place it above the 0.25 piece to form the hat top.<\/p>\n

\n
\"Jolly<\/figure>\n<\/div>\n

Remove liners from “hat” 3D Foam pieces, cover with black embossing powder and tap off the excess before heat embossing with a heat tool. Don’t worry, the foam does not melt. It’s heat resistant! Love that. <\/p>\n

\n
\"Jolly<\/figure>\n<\/div>\n

Pull liner from “scarf” 3D Foam piece, fasten a small piece of ribbon over it and press well to secure it. Use a black pen to draw stick arms for the snowman. Thread a loop piece of twine through the hole of the tag. Repeat to make multiple tags.<\/p>\n

\n
\"Jolly<\/figure>\n<\/div>\n
\n
\"Jolly<\/figure>\n<\/div>\n

All that’s left is to tie it to a package!<\/p>\n

Thanks for Visiting!
Judy Hayes<\/a><\/p>\n

Creative Time:<\/strong> 10 Minutes
Skill Level:<\/strong> Easy<\/p>\n

Materials Needed
Scrapbook Adhesives by 3L\u00ae<\/strong><\/p>\n