You are in our US store • Switch to Europe store

Teri Anderson

Sending Panda Birthday Hugs Card

Hi, everyone! Raise your hand if you like to send out handmade birthday cards to your favorite people! Teri here to show you a fun Sending Panda Birthday Hugs Card to make with basic stamping supplies and 3D Foam Shapes from Scrapbook Adhesives by 3L.

Sending Panda Birthday Hugs Card by Teri Anderson for Scrapbook Adhesives by 3L

Stamp a Birthday Scene

Start by cutting a panel of white cardstock and stamping a few birthday images in the corner and a birthday sentiment. If you are using a clear stamp, consider bending the stamp as you put it on the block to curve it over the stamped images. Color the images in with markers.

Sending Panda Birthday Hugs Card by Teri Anderson for Scrapbook Adhesives by 3L

Build a Background with 3D Foam Shapes

Take a corner rounder and round two corners. Randomly place a combination of the smaller sizes of the 3D Foam Stars and 3D Foam Circles onto the panel. Remove the liner and cover them with flock. Press into the adhesive to secure and tap off excess. Designer’s Tip: Like a little bit of glitz? Then use Metallic Transfer Foil instead.

Fill in more of your design by adding some sequins or small clay pieces to it. Use Adhesive Dots Small to secure each one to your panel. Next, add two Creative Photo Corners in Black on two opposite corners. Designer’s Tip: I find it helpful to apply a bit of E-Z Runner® Petite Permanent Dots on the back of the corners before adding the photo corners.

Add Some Finishing Touches

This panel might be a little bulky. Rather than using strips of Crafty Foam Tape to anchor it to a card, use a 3D Foam Creative Sheet instead. Simply cut the sheet down to fit your panel.

Sending Panda Birthday Hugs Card by Teri Anderson for Scrapbook Adhesives by 3L

Finish your card by adding some dots or stitch marks around the panel with a marker. Add a cute twine bow to your critter with an Adhesive Dot to secure it in place.

I hope you enjoyed today’s tutorial! I’d love to see the next birthday card you create! Share it with me by leaving a link in the comments.

Happy Creating!

Teri Anderson

Creative Time: 60 minutes

Skill Level: Beginner

Materials needed:

Scrapbook Adhesives by 3L®:

3D Foam Stars, 3D Foam Creative Sheets Mix and 3D Foam Circles White Mix

Adhesive Dots Small

E-Z Runner® Petite Permanent Dots Dispenser

Creative Photo Corners Black

Other: Cardstock: Neenah; Stamp: Ranger (Simon Hurley Big Hugs Stamp Set); Ranger Ink; Black Ink Pad; Clay Circles: Buttons Galore & More; Markers: Copic; White Flock: Stampendous; Jute: Lawn Fawn

Save to Pinterest!

Sending Panda Birthday Hugs Card by Teri Anderson for Scrapbook Adhesives by 3L Pinterest

We appreciate your comments