You are in our US store • Switch to Europe store

AJ Otto

Glittered Thank You Card using Adhesive Sheets

Hiya!  AJ here today to show one of my favorite ways to quickly add glitter to your die cuts.  It’s wedding season, grad season, dad season; etc.  With all those gifts going around, sometimes a thank you card is in need.

Sometimes you just need to add glitter to a die cut.  These things happen in our hobby.  😉


The EASIEST way to make this happen is to use your Adhesives Sheets with your dies!  Pull the yellow liner backing away and press your card stock in to place.  I often will burnish it with a bone folder to smooth it all out, not necessary, but out of habit it’s what I do. 😉

Lay your die, cutting side into the white side of the adhesive sheet and run through your die cutting machine.

AJOtto-TY-4 Gently peel back the white lining and you can start sprinkling glitter all over the exposed area.  I usually try and leave a piece to hold onto, pulling it off section by section. Once covered set aside.
AJOtto-TY-5To adhere my kraft colored layer, I used the E-Z Runner® Grand.  To adhere the white die cut, I added small dots from the Dual Tip Glue Pen all around then placed onto the card.

Perfect to say thanks to Dad on Father’s Day!

enjoy! 🙂 AJ

Scrapbook Adhesives by 3L® products used: Dual Tip Glue PenE-Z Runner® GrandAdhesives Sheets

other- dies: Spellbinders; Stamps: Spellbinders; enamel dots, thread, glitter, card stock



One Response to "Glittered Thank You Card using Adhesive Sheets"

  • Lisa Adametz