Prepare Button Snowman Tag Base
Use tag dies and die-cutting machine to cut Kraft tag about 2 x 3 inches in size. Then stamp a greeting at bottom of the tag with black ink.
Build Button Snowman
Apply Adhesive Dots Medium Ultra Thin to the back of a 0.75-inch button and place it on the tag.
Cut about 0.5-inch piece of 3D Foam Strips Black and attach it at the top of a button slightly offset to the right edge of the button. Next, place Adhesive Dots Medium Ultra Thin on the back of a 0.5-inch button and fasten with holes horizontal (eyes) next to 3D Foam Strips Black.
Cut a 0.25-inch piece of 3D Foam Strips Black to place at the top of the snowman’s head to make a hat base. Also, cut a 0.125-inch piece of 3D Foam Strips Black and place it above the 0.25 piece to form the hat top.
Remove liners from “hat” 3D Foam pieces, cover with black embossing powder and tap off the excess before heat embossing with a heat tool. Don’t worry, the foam does not melt. It’s heat resistant! Love that.
Pull liner from “scarf” 3D Foam piece, fasten a small piece of ribbon over it and press well to secure it. Use a black pen to draw stick arms for the snowman. Thread a loop piece of twine through the hole of the tag. Repeat to make multiple tags.
All that’s left is to tie it to a package!
Thanks for Visiting!
Creative Time: 10 Minutes
Skill Level: Easy
Scrapbook Adhesives by 3L®
Other: Imagine Crafts/Tsukineko Versafine Onyx Black Ink; Little B Tags Dies; Taylored Expressions “Many Minis – Holidays” Stamp; Ranger Black Embossing Powder; White Buttons (about 0.5 and 0.75 inches); Narrow Ribbon; Kraft Card stock; Black Uni-Ball Signo Pen; Twine
Save to Pinterest!